Unicyclist Community

Go Back   Unicyclist Community > Unicycling Discussion > Unicycling Articles and Tutorials

 
 
Thread Tools Search this Thread Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old 2019-03-24, 08:14 AM   #6
Matt B
Unicyclist
 
Join Date: Mar 2019
Location: michigan
Age: 61
Posts: 16
45 in-lbs is about 4ft-lbs. The same as hanging a 4lb weight on the end of a 1 foot long wrench =8lbs on a 6 inch long wrench, etc. So grab your wrench 6" away from the bolt and apply the same force as lifting a 1 gallon jug of water (gal =8.3 lbs, so at 6 inches =4.15 ft-lbs). Or better yet hang the jug by fishing line on the wrench (just make sure the wrench is parallel to the ground at the point it tightens, so you have a true 90 degree gravity vector force). Personally, I just snug up until no play in the wheel and feels feels smooth (a firm hand grab on the frame) when the wheel is spun.
Matt B is offline   Reply With Quote
 

Tags
bearing, bolts, tightening


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
My bearing holder bolts keep working their way loose. Help? Nakedbabytoes General Unicycling Discussions 16 2015-06-24 08:03 AM
Where to get ti Hardware/ kh bearing holders, seat post clamps/ seat bolts wickedbob General Unicycling Discussions 19 2008-11-23 12:21 AM
Making the bearing cap bolts good and tight. Chrashing General Unicycling Discussions 20 2008-02-25 02:04 AM
Bearing problem: Stuck/Shifted bearing Evan Byrne General Unicycling Discussions 26 2007-08-03 06:01 PM
spoke tightening MrBoogiejuice General Unicycling Discussions 8 2004-02-12 03:48 AM


All times are GMT. The time now is 07:26 AM.


Powered by vBulletin®
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Copyright © 2001-2019 Gilby
Page generated in 0.07437 seconds with 13 queries