View Single Post
Old 2016-01-21, 07:21 PM   #15
saskatchewanian
ERIC P
 
saskatchewanian's Avatar
 
Join Date: Jan 2007
Location: La Ronge, Saskatchewan, Canada
Age: 33
Posts: 6,450
If you are using spacers and everything is snugged up a loose fitting bearing should be a non-issue. Gluing should only be necessary with square taper or other systems that do not use a spacer between bearing and crank.

Have you tested your wheel after since you put it back together? If the problem is solved there is no need to break out the loctite and new bearings.

Could you describe the noise a bit better? If the noise continues with the wheel re-installed I would look at your pedals, or possibly the hub if it is built with a keyway or pressed on flanges.
__________________
My friends, love is better than anger. Hope is better than fear. Optimism is better than despair. So let us be loving, hopeful and optimistic. And we’ll change the world. - Jack Layton
saskatchewanian is offline   Reply With Quote
 
Page generated in 0.02860 seconds with 9 queries