View Single Post
Old 2012-05-18, 01:05 AM   #4
Justin LE
Mad Scientist Type?
Justin LE's Avatar
Join Date: May 2010
Location: Vancouver
Age: 34
Posts: 104
Bend Check

The curves matched the CAD printout OK, but then moving the bend into the 3rd dimension was going to be tricky. Reference marks helped a lot. The 2nd line here is where the tube needs to twist so that the bending comes out of plane and goes inwards toward the seattube.
Attached Images
Justin LE is offline   Reply With Quote
Page generated in 0.04477 seconds with 9 queries