View Single Post
Old 2012-05-18, 12:58 AM   #2
Justin LE
Mad Scientist Type?
 
Justin LE's Avatar
 
Join Date: May 2010
Location: Vancouver
Age: 33
Posts: 104
Bending Dies

Plywood disks were cut out on a bandsaw to act as a bending die. In the model, most of the bending is with a 100mm radius, and so with the wooden disks cut out at a 90mm radius the metal would spring back to 100mm pretty consistently.
Attached Images
  
Justin LE is offline   Reply With Quote
 
Page generated in 0.05406 seconds with 9 queries