KH Moment hub/crankset and Nimbus Frame

[Émile Mathieu-B.]

*Move this to the correct place, sorry, I jsut figure out that it was question on THE SITE*

Hi, maybe there is already a thread about this, but I want a clear answer.

I asked Darren of bedford unicycle for that, but he does not have the answer because he does not sell nimbus frame.

since i'm preatty pleased with almost all my unicycle part (Like the nimbus trial on unicycle.com)I started to do bigger drops and I bented my cranks....:mad: I would like to get my uni strong before all pieces brake in my hand. So buy the hoppley and not the nimbus trial if you buy it at unicycle.com

I would like to buy:

2007 KH Moment hub and crankset

and put it on my Nimbus II frame like this one Click here to see the picture (http://www.unicycle.com/shopping/shopexd.asp?id=744)


So I would simply like to know if:


2007 KH Moment hub and crankset
and
Nimbus II frame
would fit togheter.

I do not want to buy something that does no fit with my frame and have to buy a new frame...

[Jerrick]

I have tested this myself, and same with others from these forums, and have put the 42mm bearings of KH or other brands of hubs, into the 40mm bearing holders of the Nimbus frames.

So yes it will fit. Doesnt seem like it, but because the bearing holders on Nimbus frames are not machined, they have some more clearence to bearing holders that are machined, this gives it just the right ammount to fit the bigger bearings in.

[thejdw]

just make sure you use the right type of crank extractor