Announcement

Collapse
No announcement yet.

Remove vintage Schwinn cranks

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Remove vintage Schwinn cranks

    Any videos on how to remove cranks?

  • #2
    I've never seen a video about it. I'm assuming you're refering to cottered cranks since you mention "vintage". I just wanted to recommend looking for a vintage bicycle repair book. I am familiar with cottered cranks, if you have that type of crank and have questions.

    Comment


    • #3
      If they are cotterless you will need a crank extractor. The cotterless Schwinns have aluminum rims. If it has a steel rim you most likely have cottered cranks.

      If they are cottered:

      I highly recommend picking up a couple of replacement crank cotter pins before you remove the ones you have. They are made of soft steel, and deform easily. You will have much better luck using a cotter press; however, even a lot of bike shops don't have a cotter press anymore. Hammering may get them out, but I had a customer bike come in last year that he had hammered away at, and the threaded end was so deformed I had to spend far more time getting it out than I should have.

      You can buy one, or for a few dollars, and not a lot of time you can make one out of a large "top beam clamp." as in this video:

      https://www.youtube.com/watch?v=JIIjID_KdiY
      Last edited by jtrops; 2020-01-07, 12:32 AM.
      "A properly ridden unicycle is like an object in orbit: constantly falling but never landing." -Diogenes

      Comment

      Working...
      X